Home painting Oil Based Paint Over Zinsser 123

Oil Based Paint Over Zinsser 123

Oil Based Paint Over Zinsser 123. Ive tried using zinsser bullseye 123, water based paint. Zinsser 123 (water based) zinsser cover stain (oil based) zinsser bin (shellac based) so first up zinsser 123;

Flood Floetrol Acrylic Paint Conditioner Paint Additive
Flood Floetrol Acrylic Paint Conditioner Paint Additive from www.paintaccess.com.au

Remaining paint film edges smooth with the surface. Rough sanding prior to latex. Use oil bond to mix directly in the paint.

Ive Tried Using Zinsser Bullseye 123, Water Based Paint.

1.6 out of 5 stars from 5 genuine reviews on australia's largest opinion site productreview.com.au. Over bare cedar or redwood, allow 24 hours dry time before painting. Also know, is zinsser 123 a bonding primer?

In The Past I Have Normally Sanded, Wiped With Will Bond, Then Primed With California's Grip Coat When Ever Going Over Oil.

The rest of the test pieces are all sanded quickly with 200 grit sand paper, and painted with 3 different primers. As for the jambs so far only painted with a single coat of bullseye, they are getting a second coat. Zinsser 123 water based primer, zinsser cover stain oil based primer, and zinsser bin shellac based primer.

Rough Sanding Prior To Latex.

However, i want to avoid the rub down, if possible. Zinsser 123 (water based) zinsser cover stain (oil based) zinsser bin (shellac based) so first up zinsser 123; Apparently this product can grip onto gloss paint.

While It Takes More Thinner To Clean Up An Airless After Spraying Oil Base Coatings, I Always Run A Small Amount Of Thinner Thru My Pump After.

They all held up much better than the first two in the scratch tests. Great for use on all interior surfaces & spot priming on exterior surfaces. Prime severe water and smoke stains and block

Premium Stain Blocker And Bond Coat Is Designed For Priming All Surfaces, Inside Or Out.

Furthermore, is zinsser primer good? Usually 1 coat of primer is sufficient although an extra coat of finish would be beneficial. The best way to paint on this surface is to rub down with wet sandpaper to provide a key.

Rate this post