Home painting How To Paint Chrome Motorcycle Parts

How To Paint Chrome Motorcycle Parts

How To Paint Chrome Motorcycle Parts. Some aluminum parts on harleys are chrome plated where other brands might polish the aluminum (e.g., chain guards). When looking at a rusty pile of classic motorcycle parts, it is hard to imagine their former glory.

How to Remove Rust on Chrome Bicycle Components?
How to Remove Rust on Chrome Bicycle Components? from www.foldingbike20.com

The cost to just chrome strip a motorcycle wheel starts at $100 per wheel. To paint your motorcycle, first remove the parts you want to paint and sand them down. But with hard work, most parts can be renovated.

I Wrapped The Headpipes With Lava Wrap.

Polishing the parts that you want to be polished. Before the top coat of paint can be applied, the component may need to be sanded with a very fine wet/dry paper such as a 1200 grade grit paper. Let each coat dry for 15 minutes between coats.

Spray With Etching Primer (You Can Skip This Part If You Want To Save A Buck But I Won't Paint Over Chrome With Out Doing This, I'm Paranoid).

Pchrome spray has multiple advantages over traditional chrome plating. The second is that you need to abrade the chrome surface. Type of motorcycle currently riding:

In Short If You're Going Flat Black Then Go With The Fusion.

Remember your paint job is only as good as the base under it! Whether you ride a harley davidson or drive a classic mustang, or any other car or bike adorned in chrome, a class metal finishers is at your service to relieve all your chrome restoration pain! First wet sand the chrome with 400 wet sand paper until the chrome is real dull.

But With Hard Work, Most Parts Can Be Renovated.

The cost to just chrome strip a motorcycle wheel starts at $100 per wheel. If you have chrome parts that you want to paint then watch this video and i will take you through the best tips for success. Chrome motorcycle parts and car parts are our specialty.

With A Few Exceptions, All Parts On A Motorcycle Have Undergone Some Painting Or Plating Process;

To cure it put the pipes back on the bike (wear laytex gloves so you don't get finger prints all over them or the prints. Once mixed, there is a specified time you have to use it. Fusion i believe is an enamel.

Rate this post