Curing Vht Paint With Heat Gun. I bake all my painting in the kitchen oven. Process may be accelerated by the use of a heater or heat gun.
As for the down pipes you can aim the heat gun down them for a few minites to get the nice and hot before spraying may even work for the silencer too if it is detatchable. Eastwood just came out with this paint. Seemed to work as they've held up for the past week.
Table of Contents
To Cure The Paint, Bake In An Oven For One Hour At 200 Deg F (93 Deg C).
Vht brake drum, caliper and rotor paint will dry to the touch in 15 to 30 minutes depending on humidity. 2016 granite crystal scat pack, hc lower intake, dips screen, tazer and yellow pinstripe. After allowing the paint to dry, you can use a heat gun to cure the vht flameproof paint.
Vht Is Vague About How Long To Wait Before Curing, Only Saying Completely Dry.
Followed the instructions to a tee and had a good looking paint job before curing. I had about a half can of it left over when a really crusty/rusty mouse trap booster fell into my mitts. Meanwhile, i spoke to the manager at rustoleum and he informed me that i was supposed to heat cure the items an hour after the last coat, but that is not.
Once Dry, High Heat Must Be Further Cured To Increase Durability.
Vht flameproof coating paint claims to have silicone ceramic base and good up to 2000*. Sent from my nexus 5 using tapatalk. * bake at 200°f (93°c) for 20 minutes.
I've Tried Various Forms Of Paint From Bbq, High Heat, Ceramic, Auto Related Stuff From Autozone, And Lower End Firearm Paint.
Heat curing can actually weaken the coating if temps excede 160f if your. Vht engine enamel only attains its unique properties after correct curing. Last year, i used a bunch of rattle can vht epoxy paint to coat the chassis parts of my wife's 1967 sportster.
Stand The Heat With Vht.
Curing may also be accomplished with the inherent heat of operation. Wanting to paint an exhaust with vht paint and curing it as per instructions which say it needs to be heated to 160 degrees for between 30 and 60 minutes. Bought two cans each of primer, color coat, and satin clear so cost more than expected.